How do you connect a solar panel and wind generator in parallel?
I have an ~18v solar panel and a ~15v wind turbine. Sometimes one generates more voltage than the other. How would I get both of them to charge one ~12v battery? I can't just connect them in parallel with diodes, because in that case, only the higher voltage source gets used. Is there a special charge controller circuit that will do this?
Best answer:
Answer by David
There are controllers to do this, but they are very expensive. Why not two batteries, one for each generator and a battery 'change over' switch' on the output. When one battery is low switch to the other.
Give your answer to this question below!
Defective wind turbine generator hub for 3 blades fits delco 10si 17 mm hole | US $11.00 (0 Bid) End Date: Saturday May-19-2012 18:31:35 PDT Bid now | Add to watch list |
Related posts:
- SOLAR WIND POWER TOWER – AIR-X LAND WIND TURBINE / 10 WATT SOLAR PANEL WITH CHARGE CONTROLLER & SIDE OF POLE MOUNT / 1250 WATT AC/DC INVERTER
- Ensupra Grid Tie Inverter 500W – Power from Solar Panel, Wind Generator, Hydro or Storage Battery; 12.8VDC-29.3VDC to 110VAC
- Part 3 of Wind/Solar Controller Panel Construction Video
- Anyone know where I could access solar panel and wind generator for small home from reliable supplier? Thanks?
- How should i make a small wind turbine and connect it to an amp meter?
You could connect them in parallel with diodes because both voltage sources are higher than the 12 v of the battery that you are charging. The battery establishes the 12 v at one side of the diode and both are forward biased by the 15 or 18 v sources. The current drawn by charging the battery will drop the voltage of each source across its internal resistance to bring them both down to the battery voltage plus a diode voltage drop of about 0.7 v
Goober’s idea is correct, though it would be costly to implement at a large power load. The best and simplest way is to buy two charge controllers, each of the proper configuration for the power source, and feed them both into the same battery bank.
Placing diodes in series with each source to the battery would solve your problem. You should use a charge controller on the system to prevent overcharging the battery.
I’ve put together a relatively simple dump load circuit which diverts excess power to high power resistors. It is part of a wind charging system with inputs from wind, solar, and a DC power supply.
http://members.rennlist.org/warren/wind.html
http://members.rennlist.org/warren/rackwiring.jpg
http://members.rennlist.org/warren/dumpload.html