First attempt at cutting wind generator blades form PVC (2)

Here I rounded over the leading edge with my grinder and then used a orbital sander with fine grit paper, I ground down the trailing edge to almost a sharp point to cut down on any noise made from the spinning action.

One Response to First attempt at cutting wind generator blades form PVC (2)

  1. jcanivan

    Dave
    Good job. Can’t waite to see the finished product… Another great use of PVC. I use 2″ PVC to make gutters for my MTD collectors.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>